MSefi.com read only forum (Jan.15,2018)

Made my reservations I'll see you there

Skyy

In my experience it is not recommended to splice coax, I would replace it with a longer wire. The FORD EDIS is a 2 wire pickup and even though it it has a wiring diagram you can still end up switching the 2 wires to get the correct polarity. I would hook up the wires and then if required ...

That link is for the V2.2, this link is for MSII and 3.57 http://www.megamanual.com/ms2/

Mega tune does not have a indicator but a Stimulator such as this does (PMP led) and it allows you to test your Megasquirt for problems and minor testing of your setup . DIY Auto Tune has it, I highly recommend these for any build this falls right next to having a timing light a volt meter
http ...

I would start here http://www.megamanual.com/ms2/code.htm and use the 2.88 code, there is no code for any specific build it needs your input and tuning to tailor the code for your application. Read read read take your time and read the manual and become familiar with it there is lots of info. Do you ...

When you test MS on the stim does the fuel pump turn off in 2 seconds

I'm the phone guy and no problem, It was a pleasure to meet every one lots of good info and fun hope to do it again Thanks Dave

I think this is supper I'll be there

Dave

FYI 45* SAE fittings will fit AN and JIC except -6 and -12, I had gotten the SAE buy mistake

here are the pics of my wheel

Thanks Ill post a pic once I get the wheel back, the only cutout I have is the TDC mark and it's only about a 1/6. Thanks Dave

Thanks but I'm talking about the spacing from the harmonic balance not the pickup to prevent false triggering

I have the wheel layed out for my hamonic balacer, is will a 0.15 gap from the balancer be ok. Thanks Dave

If I remember right GM went to metric fittings and you can use this adapter or other brand I think there is 1,14mm and 1,16 mm fitting.
991954ERL -6 AN Male to 14mm x 1.50 Male http://www.holley.com/991954ERL.asp

Welcome to the site Steve
It sounds like a real good project 40 Delx nice , On your manifold do you have inboard or outboard injector fittings. How much of the old school do you want i.e. fuel lines or fuel rail, injectors inboard or out. If the injector bosses are on the outside then you can use ...

You will still have to set you base idle speed with the throtle bades at oper. temp, the IAC will control your fast/ warmup idle speed. As you reach oper. temp the IAC will close.

I got a cutter from Kinsler Fuel injection (rental) for my rail , I'm using Oring boss but they have other cutters to