I don't know what went wrong however i tested the relayboard and everything seemed fine.
When i connected the ms again and fired up the car i was getting correct readings.
There probably was a bad connection or something.
Thanks anyway.
Search found 3 matches
- Wed Aug 04, 2010 12:16 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: O2/AFR not updating correctly
- Replies: 3
- Views: 309
- Tue Aug 03, 2010 2:03 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: O2/AFR not updating correctly
- Replies: 3
- Views: 309
Re: O2/AFR not updating correctly
Thanks for the reply,
I did not know the sampling was triggered by the tach signals and as i'm using the negative coil trigger mechanism i had to reinstall the jumper over the zener diode first to make it work with the stim again.
Now it is updating correctly using the stim so i know there is ...
I did not know the sampling was triggered by the tach signals and as i'm using the negative coil trigger mechanism i had to reinstall the jumper over the zener diode first to make it work with the stim again.
Now it is updating correctly using the stim so i know there is ...
- Tue Aug 03, 2010 7:12 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: O2/AFR not updating correctly
- Replies: 3
- Views: 309
O2/AFR not updating correctly
Hello,
Yesterday i finally got my car running with my MS2. (The project was "sleeping" for a while).
Everything works fine except for the AFR that does not seem to update.
I'm using the folowing:
- V3.0 board
- MS2 running 2.891 firmware
- Innovate LC1 wideband lambda sonde
After some ...
Yesterday i finally got my car running with my MS2. (The project was "sleeping" for a while).
Everything works fine except for the AFR that does not seem to update.
I'm using the folowing:
- V3.0 board
- MS2 running 2.891 firmware
- Innovate LC1 wideband lambda sonde
After some ...