MSefi.com read only forum (Jan.15,2018)

Ok, thank you
as you say, it is certainly easier to go just through with a cable gland, there will be less risk of errors or bad contact.

Hello
I am looking for a connector to wire my MS, between the megasquirt case in the car and the relay board which will be in the engine bay.
I don't like the idea of just drilling a hole and letting the cable pass though, I would prefer to find a clean solution with a connector.
Would this type of ...

Thank you, i will try that, we can also find these sensors in european ford I think.
Concerning the wiring, is the HEI module still needed to convert the signal to square wave, or is it possible to hook it directly on the 3.0 board?

Is there a specific wheel design to use with this sensor? doesn't it need a wider wheel?

Hello,
I am new on this forum.
I plan on using megasquirt on my 383 sbc engine, on a 67 Camaro.
I prepared the trigger wheel, which is now installed on the engine, but I have some problems finding a matching sensor.
I am looking for a VR or hall sensor.
the wheel is a 60-2 , made of 3mm steel, the ...