MSefi.com read only forum (Jan.15,2018)

I know that one wire goes to MSII and the other to power.. now.. which pin of off the MSII is designed for it? i installed everything on the board necessary for it.. but i'm not sure that it is working correctly...

THANK YOU!

Hello;

I will be running a coil directly from my ms2 v3.0, and have a couple of questions;
I have a bosh distributor with a hall sending unit with 3 wires from a vw, the ms2 wiring diagram only shows I should wire pin #2 and pin #24, but I understand that the hall sending unit has a (+), (-), and ...

Yes, I have a wideband 02 with a gauge, will be wiring to the mega squirt... Now pins 7-9 and 17-19 are grounds, should I use those and wire the sensors to the mega squirt? What I mean is for example the AIT sensor, should I wire not only pin #20 to the ecu but also the ground to either wire that's ...

Anyone? :-/

Hello everyone.. I'm itching to get my MSII v3.0 on my corrado.. everything is prepped and ready to go.. Wiring is proving to be more of a challenge than I was hoping for and after searching and reading the forums, I have come up with a wiring diagram, but it is not 100% Would anyone be able to look ...

so after some research and not touching my MSII for a week ( still testing with the STIM) i plugged it in and it was working ok, than i decided to play a bit with it and look at the PWM setting i went on Idle Control and set it as PWM Warm up than when on the idle tables and changed the first value ...

I was having an issue with step #55, what did it for me was, on mega tune, Comunications/settings and selected the right COM, make sure that the parameters are good

hope that helps

Thanks for the help!! cleared up a lot for me.. jaja.. I will be changing my TB for the one that will fit the best

once again! thank you!

Hello everyone, first time posting here in the forums..

first a little bit about the car..
1990 VW Corrado G60, converted to a 2.0 16v.
knock sensor
hall sender @ dizzy
Idle Switch @ TB
ISV (Idle Stabilizer Valve & Boost preasure regulator)
One Ignition coil
CO potentiometer
Full throtle switch ...