MSefi.com read only forum (Jan.15,2018)

me too!!! now were do I go to solve my hunting issue?

Also my wideband goes from one extreme to the next while its "hunting" thanks again!

nolan

Problem solved!

I had the wrong coil packs to the wrong plugs.

I marked 1, 2, 3 tdc marks and used a timing light to see which plugs were firing then matched them up to the correct cylinder....Problem solved.

thanks for all the help!

Now its seems to be hunting at idle but I will do some ...

thanks trakkies, I am out in the garage now hoping to get this sorted! I followed the ms directions exactly, and triple checked it, It definitely seems like a spark/timing issue. I know I have spark i just think it must be "off" or something, It does seem suspicious that #1 and #6 are sharing a coil ...

i pulled the fuel pump fuse and injector fuses, pulled all the plugs and checked each one individually for spark. All of which sparked well.

One other thing i tried was running the edis in limp home mode by disconnecting the saw and pip wires from the relay board and the motor would not start at ...

Still cant get 1 and 6 to fire. seems a lot like a timing problem.

152624 firing order.

ok, It is definitely running on 4 cylinders. I have confirmed spark on #1 and #6 ( the cylinders not running) also verified compression and the piston appears to be "wet" indicating fuel.

i have triple checked my edis 6 wiring, I am quite positive that I have the correct pairs of cylinders on the ...

you were right Lance, I got it to start today....its spitting and popping pretty bad though.

As soon as it fired up the EGO started working properly.

Now to figure out why it spits and pops so bad. After idling for about 30 seconds I shut it down and felt the exhaust manifold. (rb25 nissan ...

it is showing 4.5volts.

gauge on the dash is reading 21.9

Hey all, Thanks in advance as I'm sure I am missing something silly!

I have traced everything I can think of and all checks out ok. I have an LC-1 working fine to the digital gauge on output 2, and the gauge to output 1, gauge is reading 21.9 (motor has never been fired yet, new LC-1) Mega tune is ...