i would have the shaft balanced anyway after it is milled a tooth off...just to retain reliability as is sits in a small bearing and is cam driven
as for the relay board...it would be appealing if it had some sort of connector for the harness as opposed to a screw terminal bus design...just maybe a ...
Search found 4 matches
- Tue Feb 08, 2011 4:37 pm
- Forum: General Information
- Topic: which ms is most suitable for the following...
- Replies: 5
- Views: 585
- Tue Feb 08, 2011 11:27 am
- Forum: General Information
- Topic: which ms is most suitable for the following...
- Replies: 5
- Views: 585
Re: which ms is most suitable for the following...
thanks matt for the pointers...ive been reading up alot and found that ms3 is great but its got tons of features i will never use making it useless for me to spend the extra cash on
so in ms2 software 3.0 i could have one tooth milled off the 24tooth wheel in the dizzy and just cut the rest of the ...
so in ms2 software 3.0 i could have one tooth milled off the 24tooth wheel in the dizzy and just cut the rest of the ...
- Fri Feb 04, 2011 9:34 pm
- Forum: General Information
- Topic: which ms is most suitable for the following...
- Replies: 5
- Views: 585
Re: which ms is most suitable for the following...
any and all help is much appreciated as i am extremely new to MS...not to electronics so im not retarded...but need guidance for this new endeavor of mine
thanks
ethan
thanks
ethan
- Fri Feb 04, 2011 9:33 pm
- Forum: General Information
- Topic: which ms is most suitable for the following...
- Replies: 5
- Views: 585
which ms is most suitable for the following...
first to introduce myself...names ethan and i have a 91 corolla 4door, roll cage, fuel cell, aluminum dash, basically setup for drag, road course....powerplant is a late 4age bigport, forged 4agze bottom end, fully built head, t3/t4 hybrid holset turbo, blah blah blah
k i have a jdm map distributor ...
k i have a jdm map distributor ...