MSefi.com read only forum (Jan.15,2018)

Its the way the prolific USB driver is written. Any disruption to the Serial port connection, and it goes nuts and crashes. You would have to write a new driver to fix it. I have the same issue on my Win7 ASUS. Good thing it boots ridiculously fast.

Now I cant get the controller to connect to the computer..... THis is really pissing me off.

I cleaned them, but I should just replace them to be sure. They were pretty nasty. I feel like my VE table was close if not right, so I should have gotten it to at least idle so I could know what to change.

Ok guys, Im sorry if this seems like a noob question, but I dont know where to start getting my engine started.

Im running MSII code vs 2.891. I got my 85 1.6L SOHC escort motor to fire and run for about a minute on the VE table in the source code. It ran so rich that it died and after cranking ...

Bad VR sensor. I figured it out.

Im running MSII with EDIS, Coil on Plug from a 4.6 Ford. I wired them in series, I have VR signal, and I cant find anything wrong with the EDIS hook up. EDIS is set in ignition settings, I have the timing set to 10 deg for now, But I cant get any spark out of it. Any ideas where to start?

Ok well Im using MSII and thats what I put in. Maybe I did something wrong. Im trying again friday, so Ill be back to let you know how it goes.

Thanks man. I was positive I put in the ECU type though. It wants MSI or MSII right? I inserted MSII. Ill go through it again though, and report back. I really appreciate this.

Ok, I have My MS-II built, and wired. I have power to the ECU, and everything works on the stim. Im running EDIS-4 with coil-on-plug. I do not have any spark. I am pretty positive my EDIS is wired right, but I cant figure this out. I am not sure where to start, so any help would be appreciated. I ...