MSefi.com read only forum (Jan.15,2018)

It is alive now. Thanks guys.

Ok I have RPM and O2 and TPS and IAT and CLT on the stim now. I put it in the car and on my mother board I have three led lights one light up as i turn the key then I got to atrat it and noe i get the second light to come on but no start . I try the same thing again and I only get on light this time ...

A number of things jump out at me when viewing your msq. I am sure there are others but here are a few.

Yout msq is set to MicroSquirt not MS2

Two point correction for Prime, ASE, WUE, etc.

Fuel calculation is set for a V8 - is this correct?

Idle control is set to 15 minute IAC - is this ...

I dont know what is a 2.89 code?

Yes but It is running a WB 02 Not NB 02. This is a Megasuirt 2 with a v3.57

Hopefully i down loaded it right.

Ok this is going to be a real dum question but what is a MSQ . LOL

It will not up load .

Sorry, But can you help me with ? And how do go about posting my MSQ?

This car was working very good It put down 508 HP on 12.5 psi on boost

Plus I check the inline fuse for the injectors and it was good. I check the injectors with A NOID Light and no juice to the injectors , But I do ahve spark when I turn the car over. With my spark plug tester but the MS2 in not seeing RPM. And if i take the MS2 out and use the stim to see if i get ...

The fuel presure is at 48 psi at the rail . The car was running and the shut off and I went to crank it back up and it would not start back up . Matt at DIYAUTo Tune said that My MS2 is not seeing RPm and will not turn on the injectors. I have the preassembled MS2 Box with the V3.57

My car was runing on MS2 but now it just shut down and will not start back up will crank but will not fire up , But I do have spark at the plug and now palse at the Injectors and the fuel pump runs and the shut off afer about a min .

Any help would be grat at this point.