MSefi.com read only forum (Jan.15,2018)

300 ohms wi + on the tab - on the sink.(each)
315 ohms wi - on the tab + on the sink. (each)

For the ouput section construction the manual says, "After assembly, check that you have very high resistance between the metal tab of both Q9 and Q12 and the heat sink. If you get less than about 60K Ohms (± 20K Ohms) resistance, you MUST correct it."
I did this and one transistor was isolated one ...

That worked! Thanks! :D
I thought that Megatune would not work with that late a firmware, I must have misread something.
I get a boatload of errors on startup in Megatune, Tuner Studio seems to not have the errors.
I will attempt to reload a fresh 2.90500.
Thanks again. Have a great Thanksgiving ...

Is this what you want?
See attached.
Tnx.
J.B.

With 5 V jumped to TSEL, I get .09 volts at pin 14 of U1. With no voltage jumped, I get 4.19 VDC at pin 14 of U1.
Mods.... please move my post to the correct forum. Sorry, not off to a good start!
J.B.

Good morning,
My name is J.B.
I am in the process of building an MS-II V.3.. I am running MSII Rev 2.905, processor type MS-II daughterboard.
I passed the power supply and communications tests and have completed the input section.
I am not seeing any tach input. If I power down I can vary the other ...