Thank you Ken.
After looking closer at the schematics, and discussing with a friend who is more literate than I regarding these matters, it sounds like everything should still function properly.
Thanks again,
Bill
Search found 2 matches
- Mon Jun 04, 2012 6:44 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Bridged pins 13 and 14 on MAX232 (did I hurt it?)
- Replies: 2
- Views: 236
- Mon Jun 04, 2012 8:56 am
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Bridged pins 13 and 14 on MAX232 (did I hurt it?)
- Replies: 2
- Views: 236
Bridged pins 13 and 14 on MAX232 (did I hurt it?)
My MS1, V3.0 has been powered up with pin 13 (R1in) and pin 14 (T1out) on the MAX232 solder bridged. I discovered this during troubleshooting bad comms (wasn't able to get a boot prompt to load new firmware). Question now is, did I fry anything by powering it up in this condition? Did I kill the ...