Fixed without any fuss.
Had my honda running great, but starting was nearly impossible... Determined there was just too much noise to ever use the VR's sucessfully, so i will just be going hall/coil on plug sooner than I thought.
I believe the VR can be used to read my AEM hall effect cam sensor ...
Search found 3 matches
- Sat Aug 24, 2013 2:22 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Screwdriver slipped during VR adjustment... D19 dead
- Replies: 4
- Views: 423
- Wed Aug 14, 2013 9:29 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Screwdriver slipped during VR adjustment... D19 dead
- Replies: 4
- Views: 423
Re: Screwdriver slipped during VR adjustment... D19 dead
Thank you. Ill post results next week.
- Mon Aug 12, 2013 10:23 pm
- Forum: MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting
- Topic: Screwdriver slipped during VR adjustment... D19 dead
- Replies: 4
- Views: 423
Screwdriver slipped during VR adjustment... D19 dead
First post, unfortunately its not a success story just yet.
My first MS build has been going fairly well so far, I have built a MS2 3.0 for my honda and managed to slip while adjusting the "top" vr pot R52. The screwdriver head ended up arcing r17, d3, and or R30.
I have done a fair amount of ...
My first MS build has been going fairly well so far, I have built a MS2 3.0 for my honda and managed to slip while adjusting the "top" vr pot R52. The screwdriver head ended up arcing r17, d3, and or R30.
I have done a fair amount of ...