MSefi.com read only forum (Jan.15,2018)

Have adjusted the trim ports too. But still no signal
I've added a BIP373 coil driver transistor ( Q16). Should the jumper from JS10 to the middle leg of Q16 still be there after I've installed q16 too, or should this be jumpered to another place?
At the V 3.0 card the D1 is not to be installed ...

Can anyone help me with this problem. The ECU doesn't read any signal from my VR-sensor.
Which changes do I have to do to my V 3.57 card to read VR signals?
I know the signal is ok, because I have run this setup on a v 3.0 before.

I use a 9v battery.
But I hooked the ECU into the car again, and now it works just fine... Strange......

When I hook the stimulator on to the ECU, it resets the ECU all the time...

Hi, I need some help.
I have a V3 board with MSII Daughtercard mounted.
Suddenly my TPS does not work anymore. It reads out 117% in Megatune. When I try to calibrate it, and try to Get Current value it reads out 1024 when the throttle is off.
I have meassured the TPS with a multimeter, and it ...