I just installed a stock MS-II v3.57 (from DIY) without the VB921 in my Dodge Raider Truck (4 cylinder) but I can't figure out how to hook up the ditrubutor/ignition. I will eventually be going with a EDIS system but I'm waiting on a custom crank pulley with the trigger wheel but it is not ready yet.
So I want to run the MS in fuel only for now and just use the stock distributor for now but can't figure out what to wire to what. I have uploaded the stock ignition circuit diagram here http://www.austincs.com/public/ignition_circuit.jpg
I would really appreciate some help as my wife wants her car back!
David.
Need distributor help please, urgent.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Need distributor help please, urgent.
That picture doesnt help much as i have no idea what kind of pick-up it uses, however if you are planning just fuel, pull your tach signal of of the negative coil wire and set up your MS for a distributer http://www.megamanual.com/ms2/pickups.htm for MSII, should be the same for MSI as well, just use the opto circuit with the caps and diodes installed.