I have a strange problem with my setup, it shows an increasing PW with increasing MAP and TPS but my RPMs drop and the engine RPM drops slowly and eventually stalls.
any ideas?
here is the MSQ and log file
newbie question
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
devastator
- Experienced Squirter
- Posts: 333
- Joined: Mon Feb 11, 2008 10:19 am
- Location: Kinda near Tucson Arizona
Re: newbie question
Do you have an O2 sensor? Sounds to me like it might have run too rich and stalled, although you should have smelled this. You might have run out of fuel to the injectors which would make it do to this too, and you would not smell it. Sorry I can't look at your log or MSQ right now,
Sandrail-ACVW 2276 cc, Turbo
MS-II W/spark burning E85
The sand must be punished.
MS-II W/spark burning E85
The sand must be punished.
Re: newbie question
fuel filter on HP pump inlet was plugged, cleaned it out and runs great 