MSefi.com read only forum (Jan.15,2018)

Cars nowadays are using electric systems to control the Butterfly Valve (based on the TPS read) instead of the traditional mechanic control. These system is called drive by wire ( http://en.wikipedia.org/wiki/Drive_by_wire ).

I wanna known if the ms2 code already supports it.

Thank You!!!

ps: http://en.wikipedia.org/wiki/Electronic ... le_control

fcasanova wrote:Cars nowadays are using electric systems to control the Butterfly Valve (based on the TPS read) instead of the traditional mechanic control. These system is called drive by wire ( http://en.wikipedia.org/wiki/Drive_by_wire ).

I wanna known if the ms2 code already supports it.

Thank You!!!

ps: http://en.wikipedia.org/wiki/Electronic ... le_control

MS2 can be used with a stock ECU or other device controlling the drive by wire, but will not run the drive by wire control itself.

Lance is working on a way to get the GPIO board to handle drive by wire control, although I'm not sure on the status of that.

Again, thanks a lot!