No crank condition
Posted: Sat Mar 05, 2011 6:02 am
I had a firmware corruption issue yesterday that wiped out my fuel table and more. I reflashed it on the side of the road with the same firmeware 2.890 as i had flashed it with before. It ran ok on the way home. Got home and started resetting the setting i needed for cold starts. It started a few times and now it just spins over. It has a tach signal cause the injectors are firing. Plugs was wet as well. Ignition is brand new outside of the distributor base. MSD cap Taylor wires autozone coil autolite plugs. I just got a set of injectors i was going to install with a new fpr as well. Pulling the ecm is next up as well to check it for bad solder joints and more.
tbi unit
gm hei 8 pin module
Ms2 v3.0
I dont have a datalog and the msq is sitting at home with my vehicle. Ill get it posted after work.
tbi unit
gm hei 8 pin module
Ms2 v3.0
I dont have a datalog and the msq is sitting at home with my vehicle. Ill get it posted after work.