Search found 10 matches

by Joe Clark
Tue Oct 30, 2012 6:17 am
Forum: Palm/Phone Based Software
Topic: Introducing Shadow Dash MS
Replies: 24
Views: 5750

Re: Introducing Shadow Dash MS

Is there any possibility that shadow dash (and for that matter tuner studio and shadow logger) could be adapted to support megajolt? not sure how different the comms are between them.
by Joe Clark
Mon Oct 29, 2012 4:36 am
Forum: TunerStudioMS
Topic: Transfer TS to another laptop.
Replies: 6
Views: 582

Re: Transfer TS to another laptop.

Ive had good success with PCMCIA 232 cards. worth a go for not much money
by Joe Clark
Sun Oct 21, 2012 3:49 am
Forum: Wiring and Sensors
Topic: LC1 Gone crazy
Replies: 8
Views: 511

Re: LC1 Gone crazy

I used to run an LC1 and had similar issues, apparently the older ones were quite bad for throwing a wobbly if they were subjected to noise, I think what they did was perform a calibration while running, or they would need the setings for the outputs reflashed.

I ended up moving to another type of ...
by Joe Clark
Mon Oct 15, 2012 9:11 am
Forum: Tuning Fuel and Air
Topic: new MS2 build showing PW with no rpm
Replies: 2
Views: 282

Re: new MS2 build showing PW with no rpm

Ok Fair enough,

But shouldnt the PW still drop to 0 with no rpm? or does it show the last value.
by Joe Clark
Sun Oct 14, 2012 2:18 pm
Forum: Tuning Fuel and Air
Topic: new MS2 build showing PW with no rpm
Replies: 2
Views: 282

new MS2 build showing PW with no rpm

Hi Folks,

Ive just put together an MS2 for a freind on a V3 board, just got to the stage where Ive stuffed the code into it (2.905) and testing it on the stim...

with no RPM I'm getting a Pulse Width reading which seems a bit odd, it does not alter with any pot changes except if I change the ...
by Joe Clark
Tue Apr 03, 2012 12:05 pm
Forum: Palm/Phone Based Software
Topic: Android App
Replies: 8
Views: 1918

Re: Android App

ooooh! I cant wait!

Ive just got shadow logger up and running, and I'm loving it.... soooo convinient, and the ability to log GPS speed is briliant :)
by Joe Clark
Sun Feb 19, 2012 4:44 am
Forum: Wiring and Sensors
Topic: O2 sensor on a turbocharged motor
Replies: 1
Views: 285

Re: O2 sensor on a turbocharged motor

the sensor needs to go after the turbo, pressure will affect the reading. also there is a mx tem for the sensor so it needs to be a little way from the turbo, some sensors say 15" away but I have seen them much closer on small 4 cyl engines with no issues (like 3-5")

I'm not really up on V8's, but ...
by Joe Clark
Thu Feb 09, 2012 10:51 am
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Turbo upgrade/ignition timing
Replies: 4
Views: 348

Re: Turbo upgrade/ignition timing

the new inter cooler should move you further from det still,

but of course nothing is ever guarenteed! :lol:
by Joe Clark
Wed Feb 08, 2012 11:32 am
Forum: MS-II Ignition Setup, Tuning, and Troubleshooting
Topic: Turbo upgrade/ignition timing
Replies: 4
Views: 348

Re: Turbo upgrade/ignition timing

I would expect the larger turbine to drop the exhaust manifold pressure, I would expect this to reduce pumping losses and heat in the engine and move the engine away from det, may be wrong on that though,

also depending on the change of efficiency of where the engine is running on the new ...
by Joe Clark
Fri Feb 09, 2007 10:07 am
Forum: Injectors, Fuel & Air Supply
Topic: Smallest Injector Out There?
Replies: 2
Views: 547

I have just bough some pico's, althogh i needed somthing a bit bigger (460cc upwards) i did find some pico injector info for production cars,

many pugs and fiats have pico's in the low 200cc area,

any bigger than that and youre looking at aftermarket pico's namly the 329cc IWP049 and 491cc IWP069 ...