Hi Folks,
Ive just put together an MS2 for a freind on a V3 board, just got to the stage where Ive stuffed the code into it (2.905) and testing it on the stim...
with no RPM I'm getting a Pulse Width reading which seems a bit odd, it does not alter with any pot changes except if I change the coolant temp and then cycle the power, also I can try it with an RPM reading at the moment as my stim is playing up.
Its been a while since Ive looked at MS, and this is the first MS2 set up Ive done (normally run MS2extra) is this normal behaviour related to ASE or warmup ect, or does it sound squiffy?
I should add Ive reblown the code a couple of times now and am seeing the same thing.
Thanks,
Joe
new MS2 build showing PW with no rpm
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Master Squirter
- Posts: 475
- Joined: Thu Oct 29, 2009 12:54 pm
Re: new MS2 build showing PW with no rpm
JC,
You need to have an RPM signal to see changes in the pulse width.
Lance.
You need to have an RPM signal to see changes in the pulse width.
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Re: new MS2 build showing PW with no rpm
Ok Fair enough,
But shouldnt the PW still drop to 0 with no rpm? or does it show the last value.
But shouldnt the PW still drop to 0 with no rpm? or does it show the last value.