Surely if the MS sensor is in the top hose after the thermostat the sensor will not reflec the warm up cycle of the engine and thus the MS will not be getting a linear input of the engine warming?
Shoot, I have no clue where the best location for it is, I work on air cooled :D Just make sure it is ...
Search found 4 matches
- Fri Mar 27, 2009 5:32 am
- Forum: Wiring and Sensors
- Topic: Adding a second Water temp sensor - Physicaly
- Replies: 12
- Views: 1062
- Thu Mar 26, 2009 11:14 am
- Forum: Wiring and Sensors
- Topic: Adding a second Water temp sensor - Physicaly
- Replies: 12
- Views: 1062
Re: Adding a second Water temp sensor - Physicaly
Don't change the location of your stock sensor. It doesn't really matter where you put the new sensor for the ms. It does what YOU tell it to do. What you can do is put the sensor somewhere that gets good constant flow over it, then start the car and get it warm based on what the oem temp gauge ...
- Tue Mar 17, 2009 8:28 am
- Forum: Tuning Fuel and Air
- Topic: Question re: fuel correction
- Replies: 5
- Views: 629
Re: Question re: fuel correction
i don't see the column for E-85 fuel correction and I would like too. How do i make that happen, is it a default on Megalogviewer? I do have the sensor and would like to see if it is actually working. BTW i have MS2 Extra 2.0 Thanks,
Chip
Chip
- Sat Aug 09, 2008 3:21 pm
- Forum: OEM EFI Hardware
- Topic: PWM idle for Bosch valve 0 280 140 516
- Replies: 17
- Views: 4783
Re: PWM idle for Bosch valve 0 280 140 516
Hi there. I picked up a Bosch idle valve (0 280 140 551) today for my MS application. I am running MS2 PCB 3.0. I am still in the construction stages so this is not yet a running vehicle. According to step 62 in the assembly instructions I am supposed to put a diode across the idle valve itself. How ...