Map sensor location

For discussing how to choose sensors and create a wiring harness for all Bowling and Grippo versions of the MegaSquirt® EFI controller.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Ian Thompson
MegaSquirt Newbie
Posts: 5
Joined: Tue Jan 09, 2007 2:33 pm
Location: Northern Ireland

Map sensor location

Post by Ian Thompson »

I am running a 90 scirocco on throttle bodies from an r6 yamaha. Where do i take my map reading from? There is no manifold as such. Each throttle body is attached directly to each intake port. Would i connect each throttle body vacuum line together then connect it to the map sensor.

Thanks
Top
Ian Thompson
MegaSquirt Newbie
Posts: 5
Joined: Tue Jan 09, 2007 2:33 pm
Location: Northern Ireland

Post by Ian Thompson »

Gentlemen, thank you.

Just one more piece of advice please. Should I drill a small hole in each throttle body and feed the vacuum line in there?

Ian
Top
Post Reply

Return to “Wiring and Sensors”