Step 71 R37 & R38

The forum to discuss:
- V2.2, V3 assembly,
- V2.2, V3 troubleshooting, and
- Connection troubleshooting
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
bonzoronnie
MegaSquirt Newbie
Posts: 2
Joined: Mon Mar 02, 2009 2:29 am

Step 71 R37 & R38

Post by bonzoronnie »

Hi all,

I am nearing completion of my Megasquirt 11 V3

The Kit from DIYAutoTune did not include R37 & R38 for the current limit circuit outlined in step 71 of the construction guide.

I was going to use jumpers as the alternative option describes. but am unsure as to where exactly to place them.

Do the jumpers bridge the two holes in the circuit board or do they fit to one of the board holes & onto the heatsink as the resistor would.

Ronnie :)
Top
bonzoronnie
MegaSquirt Newbie
Posts: 2
Joined: Mon Mar 02, 2009 2:29 am

Re: Step 71 R37 & R38

Post by bonzoronnie »

Problem solved. :)

R37 & R38 were there after all. :oops: . I was looking for the standard type of resistor. :oops:

Double checking all of the build instructions for errors. I noticed the two resistors in a sepperate pack. :RTFM:

Typical newbie error :mrgreen: :mrgreen:
Top
Post Reply

Return to “MS-II and V2.2/V3 Main Board Assembly, Testing, and Troubleshooting”