Where is a good place to pick up the switched 12V for the EDIS module? I didn't want to use the same source as the +12V switched power for the relay board since the EDIS switched 12V powers the coil and so forth. It was suggested to use the injector +12V terminals on the relay board, however, reading another post, I see that method caused someone's engine to continue running after the key was turned OFF.
Any help? Thanks in advance.
Where to get power for the EDIS module?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
supermatty
- MegaSquirt Newbie
- Posts: 2
- Joined: Mon May 12, 2008 7:39 pm
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Where to get power for the EDIS module?
You can run a separate relay that is turned on by the same power source as the 12 volt switched to the relay board.
