i have don all the wiring after the bok
but i can't get the ms too crank. have no spark.
so can sombody help a norwegia rocky?
edis on ms. no crank
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
edis on ms. no crank
i have a v3 ms 2. and a edis modul from ford mondeo.
i have don all the wiring after the bok
but i can't get the ms too crank. have no spark.
so can sombody help a norwegia rocky?
i have don all the wiring after the bok
but i can't get the ms too crank. have no spark.
so can sombody help a norwegia rocky?
-
LeslieTroyer
- Helpful Squirter
- Posts: 35
- Joined: Tue Nov 20, 2007 11:46 am
Re: edis on ms. no crank
disconnect the PIP&SAW lines between the EDIS && MS -- if still no spark - the problem is with the EDIS - not the MS.
-
Philip Lochner
- Helpful Squirter
- Posts: 96
- Joined: Thu Feb 16, 2006 5:18 am
- Location: South Africa
- Contact:
Re: edis on ms. no crank
Did you read that the VR signal is polarity sensitive? Try swopping the wires around.livip wrote: but i can't get the ms too crank. have no spark.
Best regards
Philip
'74 Jensen Interceptor Mk3 (MS-2 EFI, GPIO + GM 4L60e)
'80 Jaguar XJS 5.3L V12* (MS-2 EFI + dual EDIS-6)
and about 10 others.
Philip
'74 Jensen Interceptor Mk3 (MS-2 EFI, GPIO + GM 4L60e)
'80 Jaguar XJS 5.3L V12* (MS-2 EFI + dual EDIS-6)
and about 10 others.