Can different type of pressure sensors be used on a MSII

The forum to discuss:
- V2.2, V3 assembly,
- V2.2, V3 troubleshooting, and
- Connection troubleshooting
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
a73camaro

Can different type of pressure sensors be used on a MSII

Post by a73camaro »

Just like the title says. I am pretty certain that on a MSI the pressure transducers have to be the same. I've seen this page for the MSII and it looks like two different types of pressure sensors can be used. Like a 2.5 bar and a 1.0 bar.

Image
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: Can different type of pressure sensors be used on a MSII

Post by Matt Cramer »

Yes, they can each have a different calibration curve.
Post Reply