MS-II ignition only?

This is the place to ask general MegaSquirt® questions if you are just getting started.
Please read the FAQ and MegaManual before posting. Also see the Forum Rules. Click this link for Purchasing information.
If you are looking for MS-extra or MS-3 information, please post here: www.msextra.com
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
pcf_mark
Helpful Squirter
Posts: 56
Joined: Thu Mar 25, 2010 10:37 am

MS-II ignition only?

Post by pcf_mark »

I am trying to do my conversion in a phased approach so I have fewer systems to figure out all at once. Can I use an MS-II with EDIS and only control the spark? Once I get that working with my carb I can do the fuel side and not be trying to dial them both in at the same time. Good idea or waste of time since I will want to tune the ignition and fuel together eventually? I am just thinking about start up and getting it running easier.

Big block Chevy
Enderle IR manifold
MS-II
Ford EDIS
52# ZR1 injectors
Top
Matt Cramer
Super Squirter
Posts: 2951
Joined: Sat Jul 03, 2004 11:35 am

Re: MS-II ignition only?

Post by Matt Cramer »

Sure, that will be easier than trying to make everything work at once. The MS2 won't care that its injector drivers are disconnected.
Top
Post Reply

Return to “General Information”