Hello everybody
I read that I have to activate the CAN-bus in the S19 file to see a message on the CAN-lines
Maybe there is somebody who did this already?
If so please can you send me/us the your adapted S19 file (standard MS-II code version 2.891)
The dutch automotive teachersgroup Timloto will be very thankful
Regards,
Ep Gernaat
e.gernaat@timloto.org
firmware MS-II 2.891 and the CAN-bus
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: firmware MS-II 2.891 and the CAN-bus
It doesn't have to be activated, but to get all the latest CAN features you should use the latest code, which is 2.904 or 2.905, and the corresponding ini file. I just recently released 2.905 code and ini file here:
http://www.microsquirt.com/viewtopic.php?f=87&t=23773
http://www.microsquirt.com/viewtopic.php?f=87&t=23773