Zeitronix settings.

[ka24deroadster]

I am replacing me Innovate LC-1 wide band unit(crapped out after less than 5 hours of use) with a Zeitronix wide band unit. What settings do i use for it. The property settings only have a non-linear Zeitronix wide band. My wideband is linear. Do i set it to one of the other choices and then adjust the zeitronix output to match the settings of the other listed wideband listed.

[LT401Vette]

I'm assuming you are using an MS1?
MS2 and 3 has zeitronix linear in the calibration tool. For MS1 it would take some ini tweaking, the easiest solution is as you said, program it for something supported like the Innovate/plx 10:1 - 20:1 0-5V"

[ka24deroadster]

i have a msII. When i go to project properties/settinings/ego o2 sensor the only zeitronix setting i have is for a non-linear sensor. i am running tunerstudio version v2.0.6 .

[LT401Vette]

For MSII what is in project properties doesn't matter beyond whether you select a Narrowband or any wideband. That should probably be over ridden to only include those options.

Where you really need to set the sensor is when you calibrate the table under the menu:
Tools --> Calibrate AFR Table...

That should have the linear Zeitronix already there.