Hi
I have recently finished assembling a v3.0 msII 2.29 firmware and have a jimstim 1.5. V2.0.3
All seemed to be working ok during testing except for a problem with the TPS values not responding to input from the stim. comms with Tuner Studio got patchy and now all I get is the FP and FIDL LED blinking alternately, the only effect I can get is the INJ2LED to also flash if I turn the RPM C pot all the way up.
I have gone through the trouble shooter and all voltages seem to be fine for the processor, I have checked for dry solders and cleaned both boards with rubbing alcohol but still the same result.
http://youtu.be/EPEvcgAZIUw Here is a link to a short video.
Any suggestions?
Thanks
Simon
Ms2 v3 testing issue.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Ms2 v3 testing issue.
After another dunking in alcohol it has come back to life intermittently (so I will go over it again looking for dry solders) and now I have a firmware mismatch? Is this because I updated the Tuner Studio software?
Re: Ms2 v3 testing issue.
hi again.
upgraded firmware, all working well
sorry to bother!
upgraded firmware, all working well
sorry to bother!