Just getting started on a Motorbike TB conversion on my 2ltr Ford CVH engine (fitted in a westfield kit car)....
Was wondering if I can use my current coolant sensor (that powers the temperature gauge) that resides in the head?.....I assume this is in the correct place with relation to the thermostat?....
Also, If I can use this, can I simply take another spur from the sensor?.
Thanks.
Paul.
Coolant sensor....Can I use the one I have?.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Thanks Jim.....Currently, the car has no ECU (apart from Megajolt that controls ignition advance).......so, as I understand it, the sensor currently sat in the head of the car takes it's ground from the case, and simply has a 1 wire going back to the temperature gauge.....So, with Megasquirt install I was wondering if this can be reused?.....Although from what you say here, it seems not.....Is this because of the sensors location, or because of the sensor type?
You mention a resistor that needs removing...Is this required anyway?.
Is there a certain coolant temp sensor that is recommended....I'm in the UK, so not sure about which GM sensor to look at....
Thanks.
Paul.
You mention a resistor that needs removing...Is this required anyway?.
Is there a certain coolant temp sensor that is recommended....I'm in the UK, so not sure about which GM sensor to look at....
Thanks.
Paul.
-
wagon
- MegaSquirt Newbie
- Posts: 12
- Joined: Sun Jul 17, 2005 4:10 am
- Location: Toowoomba, QLD, Australia
Any coolant sensor will do if A) it fits B) you have some specs for it. Also, you can get '2 sensors in on' they have 2 or 3 terminals and actually have 2 separate sensors in the same body - maybe you can get one to suit your gauge and use the other for the MS. A VDO catalogue would be a good place to start - I think some VW and Audi models used these.
1984 Ford Falcon 250ci inline 6 MS'd of course!
If you are hitting your head up against a wall it always feels better when you stop.
If you are hitting your head up against a wall it always feels better when you stop.