Page 1 of 1
6 injector fuse / resistor selection
Posted: Fri Jul 03, 2009 6:37 am
by Mx73
I have a inline 6, 6 low impedence 440cc injectors. so 2 x 3 batch fire, on the diagram i have shows 2 x 2 injectors, with 2 5amp fuses and 1 2amp fuse, should i use the same configuration or increase the fuse amperage since im running 6 injectors? how should i run this
also what resistor?
Re: 6 injector fuse / resistor selection
Posted: Mon Jul 06, 2009 7:08 am
by Matt Cramer
Depends on whether you are using current limiting resistors or PWM current limiting. What board version do you have?
Re: 6 injector fuse / resistor selection
Posted: Tue Jul 28, 2009 11:14 pm
by Mx73
v3.57 ms-2
Re: 6 injector fuse / resistor selection
Posted: Wed Jul 29, 2009 5:25 am
by Matt Cramer
A V3.57 will let you either use resistors or PWM current limiting. I'd go PWM first without resistors.