MSefi.com read only forum (Jan.15,2018)

I was just reading megamanual and accidentaly fond one thing that bothers me now. I use 2.89 (MSII) because according to http://www.megamanual.com/ms2/mt28.htm 2.89 is the latest code, but here http://www.megamanual.com/files/code/ i found V3.110 code, i cannot find any information on this code what are the differences and if i can use it with my MSII

best regards

p.s. soory if i choosed wrong board

V3.110 is beta code. It can work on an MSII but is somewhat experimental at the moment. It's mostly designed to add support for the Sequencer when it comes out.

As Matt says the V3.xx code is a beta version.. its a "grand unification" of the MSII, microsquirt and sequencer code versions. The code is 100% operational and its what I am using for my engines and it works. In the near future we will update the docs to V3.xx code and this will replace the 2.8X version.

- Bruce

is there or will be any summary of changes

best regards

Absolutely. But as Matt said, most of the changes involve changes for the Sequencer and for CAN.

most, so that means there are changes also for standard usage of MS, will upgrade give me anything more than 2,89 on my SBC ??

best regards

About the only thing that is of general use is a soft cut rev limit (randomly cuts fuel with increasing frequency as you go more over the limit). Also if you have VR input problems with toothed wheels, some of the code changes may help.

nope no problems there so i will stick with 2,89, thanks for all info

best regards