MSefi.com read only forum (Jan.15,2018)

Hi

I have a problem with my Map Daddy.

Always at 416kpa (both of the two sensor). Map and Barometer

I have installed the sensor, put the right setting in sensor calibration section.
Selected the right Sensor in the configurator.

I don't know what happen.

Any Idea ?

I'll need a better description of what it's doing wrong.

Thx for your reply Matt.

I have made all your advice about configuring the Map Daddy.

In fact all gauges in MT (Map Engine and Barometer) indicate 416kpa but the engine is not running.
I assembled the Map Daddy to add a barometer correction for mountain race.

I connect another ECU but with the std Map sensor and MT give me around 98kpa.
I think that the Map Daddy ECU with Map Daddy would indicate 98kpa for Map Engine and 98kpa for Barometer. Na ?

Ok, what is the voltage reading at pin 1 and at the baro output pin?

Are you thinking about Sensor pin#1 ?
And which is the baro output ?

Can make the measures this night for me, this day for you.

Pin 1 is the square hole on the 6 pin header. The baro output is where the wire going to JS5 comes out.

Ok I made the measure:

U1 Pin#1 = 4.84V
U2 Pin #1 = 4.84V
Js5 = 4.84V

Seems to be the MapDappy default not the setting in MT, reading is always at 416.4 with small variation of the last digit.
I make a depression with my mounth on the MAP pipe with no effect. always at 416.5

I reflash the MSII with 2.888 code, made all the settings/configuration with no effect.
Made the same with the 2.890 code, and not able to open/send to the ECU the file.
Warning message appeared but I can Flash the 2.888 ....

So I keep the 2.888 code ...and the problem.

That message looks like you may have corrupted firmware - did you try loading an old MSQ on top of the new firmware or something similar?

You'll want to email the vendor you bought the MapDaddy from directly - I suspect that would be us, in which case the email address is websales@DIYAutoTune.com.

Matt Cramer wrote:That message looks like you may have corrupted firmware - did you try loading an old MSQ on top of the new firmware or something similar?

You'll want to email the vendor you bought the MapDaddy from directly - I suspect that would be us, in which case the email address is websales@DIYAutoTune.com.

Yes it is you who sold me the MS and Map Daddy .

Initially I wanted to run the computer programmed with the version (2.890) but when loading the MSQ, I got the error message.
So I reflash the old version (2.888) but this time I have the problem of MAP was blocked 416.5kpa.