MSefi.com read only forum (Jan.15,2018)

Posted: **Thu Mar 15, 2012 5:22 pm**

Been running EDIS for years and just did a fuel only install on another vehicle. Can't figure out what to set in Tunderstudio to just pull RPM from the (-) coil. I have MSII v 3.0 running 2.89. From reading some code seem to have a "fuel only" selection in the ignition setup menu but I can't find it.

Posted: **Thu Mar 15, 2012 5:37 pm**

jbb,

There is no such setting in B&G codes. If you don't want to control ignition, don't connect the ignition output. It is as simple as that.

Lance.

MSefi.com read only forum (Jan.15,2018)

Tunerstudio Setting For "Fuel Only"

Tunerstudio Setting For "Fuel Only"

Re: Tunerstudio Setting For "Fuel Only"