MSefi.com read only forum (Jan.15,2018)

Hello

MS2 B&G v2.89. I need to make shiflight and was wondering if i can do it simplest way possivble. I want to cut one of the three leds on fornt of MS like Accel LED, extend it on wiress to dashboard and put back the led, maybe use a bit bigger. Then give conditions on that port:
Accel LED (PM4):
Port PM4, enabled
variable = RPM > threshold = 6100, hysteresis = 100,
Power-on value = 0
Trigger value = 1

Will it work properly ? Can i go that way?

Best regards

WASyL,

Yes, that should work.

Lance.

good, very good thet will save me couple of bucks

best regards