How is the best way to add an extra burst of fuel, or no fuel while driving, to learn how quickly the Oxygen sensor reacts to it?
For example is there a (Control-F[Fuel]) or similar that would add a 5 ms pulse of fuel? Or a Control-Z (for Zero fuel)? This would be marked on the datalog and the Oxygen sensor could easily be checked. Mine appears to be a 5 or a 6. As I use TBI for mileage and a sensor 18 inches down the pipe.
Thanks
Holl
lambda signal delay
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bluehaze
- MegaSquirt Newbie
- Posts: 33
- Joined: Thu Apr 28, 2011 3:07 pm
- Location: Melbourne, Australia
Re: lambda signal delay
While trying to determine lambda delay, I went through a decent data log and noted all the AE points and checked them against the dips in the O2 feedback. After about a dozen or so readings, I determined a delay of about 17 cycles. This does vary a bit with engine speed and air density, but it's a good start, especially if you are using the "simple" setting in WB control.
1961 Holden with 3.3l inline 6 megasquirt fuel and ignition.