o2 reads 10v to 20v with stim?
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
o2 reads 10v to 20v with stim?
after step 55 got everything seems to work right except o2 sensor reads 10volts to 20volts. I have it set on narrow band with the 0volts to 1.0volts gauge. it does change when i move the pot, i have done the a/f calibration for a narrow band o2 cant figure out where the high voltage is coming from since the stim is powered by a 9volt. is this a calibration issue or have i done something wrong on the assy?
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: o2 reads 10v to 20v with stim?
Could you post a copy of your tune file? This may shed more light on the subject.
Re: o2 reads 10v to 20v with stim?
thank you for your reply just the suggestion that it might be in my tune configuration i went back and found i had not configured my project correctly works great now! this whole thing has been a steep learning curve! Thanks again