Page 1 of 1
o2 reads 10v to 20v with stim?
Posted: Wed Feb 06, 2013 6:15 pm
by racincrj
after step 55 got everything seems to work right except o2 sensor reads 10volts to 20volts. I have it set on narrow band with the 0volts to 1.0volts gauge. it does change when i move the pot, i have done the a/f calibration for a narrow band o2 cant figure out where the high voltage is coming from since the stim is powered by a 9volt. is this a calibration issue or have i done something wrong on the assy?
Re: o2 reads 10v to 20v with stim?
Posted: Fri Feb 08, 2013 5:56 am
by Matt Cramer
Could you post a copy of your tune file? This may shed more light on the subject.
Re: o2 reads 10v to 20v with stim?
Posted: Fri Feb 15, 2013 12:07 pm
by racincrj
thank you for your reply just the suggestion that it might be in my tune configuration i went back and found i had not configured my project correctly works great now! this whole thing has been a steep learning curve! Thanks again