Hi All
I am obviously a newb and want to learn as much as possible about this application.
I have assembled my Megasquirt 2 with v3 board. I am trying to learn as much as possible and don't want to hassle Matt at DIY to much, although he has been great with his help.
Can anyone help with the Jumper settings for what I have below!
I am not entirely sure what type of IAC I have except it off a 2003 Mazda Astina with a SR20 engine, on the throttle body the IAC controller has only 2 wires
The Ignition is going to be using the parts below!
This is my application and parts purchased from DIY.
G16A 1600cc Suzuki engine
I am fitting a small turbo charger onto it also. I want to control both ignition and fuel. I am using multipoint injection.
I purchased the list below
for my Megasquirt conversion to fuel injection with full ignition control.
MegaSquirt-II PCBv3.0 Kit
Mod kit for HEI ignition control
MegaSquirt Stimulator version 2.2 Kit
MegaSquirt relay board kit
4' cable for connecting MegaSquirt to relay board
12' Wire Bundle
Coolant temperature sensor
Intake air temperature sensor
Aluminum IAT sensor fitting
Tuning Cable for MegaSquirt EMS
USB Adapter needed for most laptops
6" crank Trigger
Hall effect sensor
I have assembled the Stimulator and relay board and most of the ECU, but I have not set any of the jumpers until I understand what I need to do.
I have made 4 of the resistor jumpers as described in the article for the quadspark http://www.DIYAutoTune.com/tech_article ... ds.htm#ms2 \
Although Matt says I only need 2 as there are only 2 Outputs (makes sense)
Thanks Glen
Jumper Settings
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Jumper Settings
If using our Hall effect sensor, we recommend configuring the board for VR input.
