troubleshooting - stuck
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
troubleshooting - stuck
hi, ive just bought a ms1 v2.2 and put it together and i have no comms, so i tried all the loop-back tests and they all passed except for the cpu one so i went to megasquirtuk and he tried his cable and pc no luck, so he put his stim on it and the fuel light flashed when he gave it rpms, so tried a different cpu and it was the same, then today i went and bought a new crystal and its still the same(back with my cpu and no stim). i have measured the resistances between the max232 ground and the voltage reg and it was 0.1 ohm as was the two lines between the max232 and the cpu. has anyone experienced anything like this? or does anyone have any ideas what it could be or where i should be looking? its my first MS and though im a auto electrician im only 20 so not too much experience. i am 99% sure there are no components in backwards, i have looked over them numerous times in the last 2days
Re: troubleshooting - stuck
If you get stuck, I can check (free) and quote for a repair, if needed, in the UK.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Re: troubleshooting - stuck
okay thanks i may have to do that. where abouts in london are you? i work in chadwell heath...
Re: troubleshooting - stuck
nevermind i was measuring the data and it just started working out of the blue. cheers for the offer