goofy question

[corysplace]

MSII-3.0 v2.890 HEI mod and iac mod.

Car runs but acts wierd. I can get car started but it acts wierd.

CurrentTune.msq

I have to give it some gas, to run ok it will run fine when i idle it down. Then it starts to spit out the intake, not backfire. I think this is cause of this. I think it runs fine cause of advancing the timing

2010-10-14_22.36.21.msl

First picture shows were TDC is in dizzy, now the sensor does not line up to this and i cannot turn dizzy far enough due to hitting something


This picture shows the were number one cylinder is.


my question is should i press off the trigger and put it back on so i can align it up with the sensor. i put a run log in in case anyone wants to see it.

[Matt Cramer]

Something's wrong with the data log. Does the timing you see in the tuning software match the timing you see with a timing light? First thing to check if you suspect a spark problem. You should not have to adjust the distributor to the limits of its travel as you can adjust the timing by changing Trigger Offset.

[corysplace]

i started it up,with the light on. and changed the trigger i finally saw it around 50. My dig. timing light is broken, so i am waiting for friend to bring his over to double check.

[corysplace]

also notice this. in the first pic. were tdc is the rotor points at 1, in the 2nd pic. the rotor is after 1(or advance correct). So shouldn't i be going down in timing?

[corysplace]

hows this look, after some trial and error i finally got car running. I ended up changing to rising instead of falling. I still have a lot of fine tuning to do but it runs.
2nd to last log

2010-10-24_11.25.59.msl

last log

2010-10-24_11.46.30.msl

just wondering what specific log files should i be viewing when using TS.