Hi,
I read a lot of threads on different forum and I would like to get informations before to jump in.
engine is a 3 cylinder, carb, with distributior ignition. I would like to convert it EFI using a TBI, and later
add a turbo to run around 8-10psi of boost.
Is MS can control correctly spark for a 3 cylinder engine ?
Which MS version I need to use ?
Is there any professional guy that can give an hand to get the correct tune for NA and turbo setup ? Not for free of course.
Thanks,
MS for a 3 cylinder engine
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: MS for a 3 cylinder engine
Sure, a 3 cylinder distributor doesn't present any special challenges. With a GM type TBI, I'd say go with MS2 for this.
Where are you located? A tuner is likely to need to have the car in their shop to map it.
Where are you located? A tuner is likely to need to have the car in their shop to map it.
