Accel Enrich help.....

This forum is for discussing ignition setup, tuning, and troubleshooting for MS-II. Click these links for info on GM's HEI, EDIS, direct coil control, others.
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.

If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0). For tuning/troubleshooting questions, please attached a datalog and your MSQ file to your post.

If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days

The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
blowngt
MegaSquirt Newbie
Posts: 5
Joined: Sun Nov 28, 2010 6:32 pm

Accel Enrich help.....

Post by blowngt »

I seem to have the VE table dialed in and now I'm starting to work on the drivability part.

I need help with the following:

- While in N, if I press on the accelerator the car seems like it's going to stall for a second, then it accelerates. It's not a 'crisp' throttle response like it should be.

- In partial acceleration, the car goes lean for a second (and bucks) just before it accerates.

Being still new to the world of tuning, I'm under the assumption that this is where I need to dial in my AE part.

Can anyone help point me in the right direction??
Bernard Fife
Master Squirter
Posts: 475
Joined: Thu Oct 29, 2009 12:54 pm

Re: Accel Enrich help.....

Post by Bernard Fife »

You could start by reading this: http://www.megamanual.com/ms2/tune.htm#accel

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it.” - George Bernard Shaw
Post Reply