MSefi.com read only forum (Jan.15,2018)

I have a strange problem with my setup, it shows an increasing PW with increasing MAP and TPS but my RPMs drop and the engine RPM drops slowly and eventually stalls.

any ideas?

here is the MSQ and log file

Do you have an O2 sensor? Sounds to me like it might have run too rich and stalled, although you should have smelled this. You might have run out of fuel to the injectors which would make it do to this too, and you would not smell it. Sorry I can't look at your log or MSQ right now,

fuel filter on HP pump inlet was plugged, cleaned it out and runs great