and can find no mention of this problem any assistance will be helpfull cheers heathMS1 V3 CONNECTING TO LAPTOP THEN GOES BONKERS
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
MS1 V3 CONNECTING TO LAPTOP THEN GOES BONKERS
Hello everyone im hoping someone can let me know where im going wrong, i have a ms1v3 that was tested working on a stim kit ok, if i connect the ecu to the loom and switch on the ignition the 1 red led light comes on indicating that power is there at the ecu, i connect the lead to the laptop, open megatune and a choice sheet appears with several choices on like car1, ms1 original bg code, ms1 extra, ms2 etc etc, i click ms1 original bg code, set port to com 3 which is the correct port, timer interval to 20, serial data rate to 9600, all ok click connect and success appears all ok until i click close and then all heck breaks loose, the screen flashes and a warning screen flashes saying something like incorrect data terminate program or terminal damage may occur or words to that effect, question is what is wrong, what data is incorrect, i tried all the other start up options and cannot get it to talk to the ecu, i have been and can find no mention of this problem any assistance will be helpfull cheers heath
and can find no mention of this problem any assistance will be helpfull cheers heathRe: MS1 V3 CONNECTING TO LAPTOP THEN GOES BONKERS
Get TunerStudio. Much easier to use.
Dave P, London UK.
Rover V-8
MSII V3
EDIS
Tech Edge Wideband
Rover V-8
MSII V3
EDIS
Tech Edge Wideband