MS1 V3 CONNECTING TO LAPTOP THEN GOES BONKERS
Posted: Thu Jul 26, 2012 9:49 am
Hello everyone im hoping someone can let me know where im going wrong, i have a ms1v3 that was tested working on a stim kit ok, if i connect the ecu to the loom and switch on the ignition the 1 red led light comes on indicating that power is there at the ecu, i connect the lead to the laptop, open megatune and a choice sheet appears with several choices on like car1, ms1 original bg code, ms1 extra, ms2 etc etc, i click ms1 original bg code, set port to com 3 which is the correct port, timer interval to 20, serial data rate to 9600, all ok click connect and success appears all ok until i click close and then all heck breaks loose, the screen flashes and a warning screen flashes saying something like incorrect data terminate program or terminal damage may occur or words to that effect, question is what is wrong, what data is incorrect, i tried all the other start up options and cannot get it to talk to the ecu, i have been 
and can find no mention of this problem any assistance will be helpfull cheers heath
and can find no mention of this problem any assistance will be helpfull cheers heath