MSefi.com read only forum (Jan.15,2018)

It`s almost the same and it`s not a problem to adjust it to fit.

Yes it`s Bosch 0 280 120 314

Hi, i have TPS sensor from Fiat Uno 1.3 turbo and the sensor itself is not a potentiometer type. It`s just a switch in first position(when the throttle is closed) it grounds the signal. The second position is the signal wire goes to 5volts (vref) when throttle is half open until wide open throttle ...

No chance at all. I`m still assembling my engine and everything in the car is a mess. So i take the battery at home next to my PC and wire everything.

It`s all voltage problem but it`s so confusing. First with DC adaptor which i used when i run portchek it finds me that I have connected com, next when i power up with the car battery portchek sees nothing connected and i thought that the board don`t work but actualy it was working and i loaded the ...

There`s somethink strange. When i power up the board with DC adaptor(13V ) it works i thought it too noisy, and then i powered it with the car batery(12.8V) it doesn`t start at all.

No i`m using comm cable.
Portchek says this
com4 opened
9600baud
triyng ' s'

I also don`t have the stimulator and i use the relay board to power megasguirt.

Hi there, i boght megasquirt kit from www.DIYAutoTune.com, i pass all the steps, but i fnished here when i try to load the code and every time i get this massege

Reading C:/Program Files/MegaSquirt/Monitor_v2.890.abs.s19:
Detected MS-II (HCS12) code.
Entry point: 0x0000
Code range : 0x4000-0x3db420 ...