I am having some difficulty understanding step 22.
I know i am not going to use a stepper motor but then it states "If you will be using an ignition output signal to control a coil or ignition module with MS-II, you will, likely be directed to jumper JS10 to:
IGN, or
IGBTIN, with IGBTOUT jumpered to IGN "
Do I need to just ignor this now and it will be addressed later?
I am going to be running this on a Volkswagon 1.8T 20v with coil on ignition (w/ built in ignitors) dual waste spark. I will be running a cable throtle body with a set screw for idle and no A/C.
Any assistance is appreciated. Thanks.
Trying to figure out step 22 (MS2 board 3.0)
Forum rules
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. Many users will not reply if the answer is already available in the manual.
If your question is about troubleshooting, configuration, or tuning, you MUST include your processor type (MS-I or MS-II) and code version in your post. If your question is about PCB assembly or modifications, you must also include the main board version number (1.01, 2.2 or 3.0).
If you have questions about MS1/Extra or MS2/Extra code configuration or tuning, please post them at www.msextra.com Such questions posted here will be moved to: a temporary MSextra sub-forum, where they will be removed after 7 days
The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Trying to figure out step 22 (MS2 board 3.0)
I am about 6 hours into this. And have made it to step 55. I highlighted this step. Because I found this and will maybe do this. http://www.megamanual.com/ms2/vb921.htm This also means I can do this jumper later.
1970 Honda N600 600cc Twin
-
Matt Cramer
- Super Squirter
- Posts: 2951
- Joined: Sat Jul 03, 2004 11:35 am
Re: Trying to figure out step 22 (MS2 board 3.0)
If you are using the MS2/Extra mods to add extra spark outputs, please check the separate MS2/Extra support forum on MSExtra.com. The MS2/Extra code makes running wasted spark pretty straightforward. With Bowling & Grippo code covered on this forum, the easiest way to do wasted spark would be an EDIS swap.
