MSefi.com read only forum (Jan.15,2018)

The tune does look like there are some weird cell values. I don't think they were like that when I tuned it 2 years ago but to be honest I don't remember all the cell values. I have not thought about any of this tuning stuff since I started driving the truck. I have not found any mechanical problems ...

I have a 1996 Chevy LT-1 with a Ford EDIS ignition system and a 5 speed manual tranny. My Megasquirt is a MSii with V2.90 code. I have been running this in my truck for over 2 year with very little problems. Every so often when I would start it, it would seam to run a little rough but if I shut it ...

i have a msII. When i go to project properties/settinings/ego o2 sensor the only zeitronix setting i have is for a non-linear sensor. i am running tunerstudio version v2.0.6 .

I am replacing me Innovate LC-1 wide band unit(crapped out after less than 5 hours of use) with a Zeitronix wide band unit. What settings do i use for it. The property settings only have a non-linear Zeitronix wide band. My wideband is linear. Do i set it to one of the other choices and then adjust ...

Have you calibrated you o2 sensor in TunerStudio? I was having the same issue of my AFR reading staying at around 12. I went to Tools - Calibrate AFR Table and re-calibrated the EGO sensor to LC-1 default and now the gauge works.

I am running a MSii on my 1996 chevy LT1 (350 V8). I have 2 Innovate LC-1 wideband O2 sensors, one for the left and one for right side of the motor. I am using TunerStudio for tunning. What is the proper Tunner studio settings for dual 02 sensors. If I use a single VE table how does the Automatic ...

Is there a certain distance that the coils need to be from the MS2 controller? I mounted my relays and fuse blocks right next to my controller to keep everything in one spot. I am close to completeing the install and have not tried to run it yet. Do I need to move my controller?

Looking at the Megasquirt-Inputs schematic at http://www.megamanual.com/ms2/ it shows the circuit connected to AD5-1. Is this where i connect the circuit to JS5? Where it shows 02, is this connected to any spare pin on the DB37 connector for the 02 sensor? What is the ADC6 reference?

How do you hook up 2 Oxygen senors? The manual states that the MSII can read 2 sensors but I can't find how to hook up the second one. I have dual exhaust on my truck and would prefer to know both side of my V8 are running right, instead of assuming because only one side is monitored.